2 x Kermi spacers for radiators, each 25-40 mm, adjustable

£9.9
FREE Shipping

2 x Kermi spacers for radiators, each 25-40 mm, adjustable

2 x Kermi spacers for radiators, each 25-40 mm, adjustable

RRP: £99
Price: £9.9
£9.9 FREE Shipping

In stock

We accept the following payment methods

Description

It’s important to measure both width and height when installing a new radiator so that you have an accurate idea of how much space you have available for installation purposes. Measure twice or even three times just to be safe – accuracy is key here! Step 5: Measure + mark your centre line Be sure of the specific heat output you require. Your new radiator will need to have the right output. For example, towel rails have a lower output than radiators so won’t keep your bathroom as warm as a radiator would. For the vertical position of the radiator, it's normal for the bottom of the radiator to be 4 to 6 inches above the floor - try to use the same height as used for any existing radiators.

Fit the tails with an adjustable spanner, winding them in until there is only one thread showing. Again, don’t screw them in too tightly, or you risk damaging your new radiator. Step 4: Measure the width of your wallYour radiator is finally on the wall – now it’s time for some finishing touches. Ensure the header tank is topped up with corrosion inhibitor and open both valves by the number of turns it took to close them off. Step 14: Bleed the radiator Studs are normally set at equal distances apart - on older stud walls they are usually no greater than 405mm (16 inches) apart, while in more modern stud walls, the maximum spacing is about 600mm (24 inches). The technology used to manufacture radiators is always improving, with better materials, designs, quality regulations and performance.

You can remove the cover from your Hive Radiator Valve to change the batteries. Remember to keep the batteries away from children as they can be a health hazard.

Apple please watch this.

If you see a few drops of water when you unscrew your old radiator control then your existing valve body may be leaking. Valve bodies can often be tightened up, but some might need replacing if they are leaking. We recommend fixing your valve body before installing your Hive Radiator Valve. Get advice from a plumber if you’re unsure of how to do this.



  • Fruugo ID: 258392218-563234582
  • EAN: 764486781913
  • Sold by: Fruugo

Delivery & Returns

Fruugo

Address: UK
All products: Visit Fruugo Shop